[j sotelo]

A quick tutorial on how to fix Eyebrows it can be very usefull sometimes!

With Photoshop open your photo then press the (Q) key that will take you Quick Mask mode. Press the (B) key to select the Brush tool, then press the (D) key to make sure the default black and white foreground and background colors are selected.
Paint with black over the right eyebrow then the left in the shape you would like to give it. The areas should appear In red, if you over do it press the (X) key to use the white foreground color and correct what you like.






Once satisfied with the shape hit the (Q) again to exit Quick Mask mode.
You will see what you masked turned into selections.





Go to Select > Feather to bring the Feather Selection dialog box. Enter a value depending on the image size (in this case I used 10) then press OK to apply the feather.






Select the Clone Stamp tool by pressing the (S) key, and choose a Soft round edge brush.

[j sotelo]

Hold down the alt key and choose a clean area near the area you are about to clone.
Clone the skin over the eyebrows, If you go over the selected or masked area don’t worry, the area inside the selected area wont be affected.






Once all the unwanted sections have been removed, press Ctrl+D to deselect.
If your happy with these results,BRAVO YOUR’E DONE !!!

If you would like a little touch more, press (R) to select the Smudge tool, Then set the brush size to 2 pixels and the opacity to 95%. Click and drag out single hairs around the eyebrow, always going the same direction as the hairs, do it until satisfied with the look..





NOW YOU’RE FINISHED !!!!!





BEFORE AND AFTER

[Steve]

Great tutorial and well written too

Thank you very much for sharing.

Rep points added

[j sotelo]

I hope its of some help, I know its helped me a lot..